Turning Lathe New

HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck


HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck
HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck
HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck
HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck
HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck
HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck
HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck
HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck
HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck
HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck

HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck   HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck

HWR InoFlex VT026 (VTS026) 10 through hole four jaw chuck. Self Centering 2 + 2 Jaw Movement. Chuck can be supplied with a A2-6 or A2-8 adaptor plate and your choice of drawtube thread up to M85 at no extra cost.

Samchully IDF 260, SMW AutoBlok CENTC04, Kitagawa HW-10. This chuck design offers unbeatable clamping flexibility; its compensating features provide the ability to securely clamp round, cubic and geometrically irregular workpieces when milling or turning. Conventional chucks operate with all jaws moving in the same direction either towards or away from the centre of the chuck whist the Inoflex® chuck operates with the jaws moving together or apart on two parallel axes. Compensation is provided to the diametrically connected base jaws by a sliding gate type gear mechanism. Chuck is new, never mounted on a machine. Uses same jaws for a Kitagawa B210 10 chuck. The VT026 is the same as the current model VTS026, the only difference is a minor. Internal design change which improved the repeatabilty slightly.

The VT-S repeats +/- 0.003mm. The VT was about +/- 0.008mm.


HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck   HWR 10 InoFlex VT026, VTS026 through hole 4 jaw 2+2 jaw movement lathe chuck