This is a Wood Lathe Bowl Chuck consisting of a PSI 4" Utility-Grip 4-Jaw Self-Centering Wood Turning Chuck with 2 Jaw Sets, plus an 8" Jumbo Jaw Set, for use on Shopsmith wood lathes with a 5/8 plain spindle and also 1-8 threaded lathe spindles. PSI 4 Wood Lathe Bowl Chuck for finishing bowl bottoms. 8 Bowl capacity with jumbo jaws installed and fully extended. Can be used as shown in the pictures on 8 lathes or larger.
Set includes: 4" Utility-Grip Chuck (w/ extra sets of jaws) + 8" Jumbo Jaw Set. 4 PSI Utility-Grip Chuck system.
4-Jaw x 4 diameter self-centering chuck threaded 1x8. With Shopsmith spindle adapter for 5/8 plain spindles.
#1 Step jaws grip OD's from 0" to 1-7/8" and ID's from 7/16" to 2-3/8". #2 Step jaws grip OD's from 0" to 1-7/8" and ID's from 1-1/2" to 3-1/4".
Round jaws grip OD's from 1-7/16" to 3" and ID's from 1-15/16" to 3-5/8". With set of 2 chuck tightening rods. With 8 extra jaw mounting screws.
With 8 pc set of 1/2 rubber coated pins. With 8 pc set of 3/4 rubber coated pins.
With set-up and operating instructions & all hardware to mount the 3 jaw sets. Chuck body is chrome plated... Jaws are black oxide finished. Jumbo Jaws are chrome plated steel. This is a super versatile 4" wood lathe chuck system for finishing the bottom of bowls up to 8" in diameter.
Safety Note: It is very important that you securely fasten the spindle adapter to your lathe spindle, and the chuck to the spindle adapter. Failure to properly secure these components can result in injury. This item is in the category "Home & Garden\Tools & Workshop Equipment\Power Tool & Air Tool Accessories\Lathe Accessories". The seller is "thirddevil" and is located in this country: US. This item can be shipped to United States.